KrosFlo® TFF System – Auxiliary Scale ACSS-60K
User Guide
15 repligen.com 420-14871-002 Rev. 00
2.
Press
key, filter values are displayed successively one by one, where:
1
- Fast,
2
-
Average,
3
– Slow.
3.
Set respective value and press
key to confirm, next go to the home screen.
Note:
The higher filter value, the longer the indication takes to stabilize.
5.2
Value release
Enter this parameter to adjust rate of stabilization of the measurement result. Depending on the
selected option, weighing time is either shorter or longer.
1.
Enter
<P2.rEAd / 2.2.APPr>
submenu.
2.
Press
key, filter values are displayed successively one by one, where:
F_P
– Fast and
Reliable,
PrEc
- Reliable,
FASt
– Fast.
3.
Set respective value and press
key to confirm, next go to the home screen.
5.3
Ambient conditions
4.
Parameter relating to ambient and environmental conditions of the workstation. Enter this
parameter and set 'nStAb' value if the ambient conditions are unfavorable (air drafts,
vibrations).
5.
Enter
<P2.rEAd / 2.3.Enut>
submenu.
6.
Press
key, filter values are displayed successively one by one, where:
nStAb
– unstable,
StAb
– stable.
7.
Set respective value and press
key to confirm, next go to the home screen.
5.4
Autozero function
‘Autozero’ function has been designed to enable automatic control of zero indication. This
guarantees precise weighing results.
There are, however, some cases where this function can be a negative factor in the measuring
process, e.g. very slow loading of the weighing pan (load adding, e.g. pouring, filling). In such case, it
is recommended to disable the function.
1.
Enter
<P2.rEAd / 2.4.Aut>
submenu.
2.
Press
key, filter values are displayed successively one by one, where:
YES
– Function
enabled,
no
– Function disabled.
3.
Set respective value and press
key to confirm, next go to the home screen.
5.5
Tare entering mode
The tare is entered using
and
keys combination. There are two enter modes.
