Premier Bench
1.8 m Free Standing, 3 Supports
www.replas.com.au
IMPORTANT:
Please read carefully before assembling
.
Assembly Instructions:
2.
Using the 65 mm hex head screws supplied, screw
the support onto the slats, taking care not to over
tighten as this could strip the thread in the support.
.
3.
Once all the screws have been tightened turn over the
bench and place it into position.
Components List:
If you require further installation assistance, please contact your supplier.
1 x Bench Top
pre
assembled
2 X Bench Supports
12 X 14g x 75mm Hex Head Screws
1.
Place bench slats face down on a flat surface.
1 x Bench Top
pre
assembled
2 X Bench Supports
12 X 14g x 75mm Hex Head Screws
4 Slats
1.
Place bench slats face down on a flat surface.
2.
Place supports inside metal frame.
3.
Using a 3.5mm drill bit, drill into support through the pilot holes in the metal frame.
4.
Using the 40mm hex head screws supplied, screw support onto frame, taking care not to
over tighten as this could strip the thread in the support.
5.
Once all screws have been tightened turn bench over and place into position.