TONiC RKLC20-S linear installation guide
12
System connection
Approved ESD precautions must be followed at
all times during readhead and interface electrical
connections. The readhead is connected to the
Ti/TD interface via a small, rugged connector to
allow for easy feed-through during installation.
Connecting the readhead
u
Remove the cover plate as shown
(2 x M2.5 hex head screws).
u
Taking care not to touch the pins, plug the
connector into the socket in the interface,
ensuring correct orientation as shown.
u
Refit the cover plate ensuring the cable ferrule is located in the recess on the inside and no wires are trapped under the cover plate.
Disconnecting the readhead
u
Remove the cover plate on the interface
(2 x M2.5 hex head screws).
u
Gently lever the connector PCB (on the end of
the cable) out of the socket.
Do not pull the cable to remove the connector.
u
Place the connector in an anti-static bag.
u
Refit the cover plate.