Renishaw NCi-6, Руководство по установке

Страница: 6 / 32

1-2 NCi-6 non-contact tool setting interface: Before you begin
Safety
In all applications involving the use of machine tools or CMMs, eye protection is recommended .
Information to the machine supplier/ installer
It is the machine supplier’s responsibility to ensure that the user is made aware of any hazards involved in
operation, including those mentioned in Renishaw product literature, and to ensure that adequate guards
and safety interlocks are provided .
Under certain circumstances, the probe signal may falsely indicate a probe seated condition . Do not rely
on probe signals to halt the movement of the machine .
Information to the equipment installer
All Renishaw equipment is designed to comply with the relevant UK, EU and FCC regulatory requirements .
It is the responsibility of the equipment installer to ensure that the following guidelines are adhered to, in
order for the product to function in accordance with these regulations:
• any interface MUST be installed in a position away from any potential sources of electrical noise, i .e .
power transformers, servo drives etc .;
• all 0 V/ground connections should be connected to the machine “star point” (the “star point” is a single
point return for all equipment ground and screen cables) . This is very important and failure to adhere
to this can cause a potential difference between grounds;
• all screens must be connected as outlined in the user instructions;
• cables must not be routed alongside high current sources, i .e . motor power supply cables etc ., or be
near high-speed data lines;
• cable lengths should always be kept to a minimum .
Equipment operation
If this equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired .
WARNINGS
Use of controls or adjustments or performance of procedures other than those specified within this
publication may result in hazardous radiation exposure .
Switch off electrical power to the NCi-6 interface before carrying out maintenance on non-contact (NC) tool
setting and tool breakage detection products .
CAUTION – LASER SAFETY
The NCi-6 interfaces with Renishaw laser-based non-contact tool setting and tool breakage detection products .
Laser safety guidelines and safety rules are described in the appropriate NC tool setting product guides .
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired .