Renishaw NCi-6, Руководство по установке

Страница: 12 / 32

2-4 NCi-6 non-contact tool setting interface: NCi-6 basics
Connectors CN1 and CN2
10-way connector (CN1)
Connector CN1 is used to connect the non-contact unit to the NCi-6 interface .
Terminals 1 – 2
Used to monitor the signal from the NC unit. Voltage range: 0 Vdc to 9 Vdc.
15-way connector (CN2)
Connector CN2 is used to connect the NCi-6 interface to the CNC machine tool .
Terminal 1
Used to select the pulse width in consideration with switch SW2-4 .
Terminals 3 – 6
This is an auxiliary output that can be used to control external devices such as LED, a buzzer or an air
blast .
This output can also be used with a hardwired NC unit to switch the transmitter unit on/off independently of
the receiver .
Alternatively, it can act as a skip-sharing module to switch between a non-contact tool setting device and
an interface for spindle probing .
This output is fused at 200 mA .
Terminals 7 – 8
This is an SSR output that can be configured to be either normally open (N.O.) or normally closed (N.C.).
The output is fused at 50 mA .
Terminals 9 – 10
This is an SSR output that can be configured to be either normally open (N.O.) or normally closed (N.C.),
as well as providing a pulsed, level or oscillating output . The output is fused at 50 mA .
Terminals 11 – 12
This is used to select the operating mode .
Terminals 13 – 15
This is used to supply power to the interface .