Start Guide
DETERMINE PATCH LOCATION
�
Plan position of where patches will be placed before
removing the liners.
�
The patches should only be placed on healthy, dry skin.
1
5
2
:10
sec
3
4
SKIN PREPARATION
�
Inspect the area to ensure the skin is:
�
Intact
�
Hairless
�
If required, remove chest hair.
�
If required, clean skin using soap and water.
�
Allow skin to dry completely.
APPLYING ZENSOR™ PATCHES
�
Remove the patch liners to expose the adhesive.
�
Place patches in the recommended position.
�
Press firmly across each patch for
10 seconds.
�
If required, coil and tape the excess wire to the skin.
ATTACH ZENSOR™ UNIT
�
Give the
BLUE
button on your unit one quick press to turn it on. Make sure the
unit is showing a
GREEN
light before attaching it.
�
Line up the unit studs with the magnetic studs on the patch.
�
Connect the unit to the patch.
�
Gently lift the edges of the unit to confirm all four connections are made.
�
Try the ‘wriggle test’ - if you cannot move the unit around, you will know it is
properly attached.
EVERYTIME A SYMPTOM IS FELT
�
Press the
BLUE
button once.
�
Remain still for 30 seconds while your heart rhythm is recorded.
1
2
3
1
2
3
Electrode Array
RA electrode patch label
LA electrode patch label
Lower left electrode patch label
RA electrode patch label
1
LA electrode patch label
2
Lower left electrode patch label
3
The Zensor™ system is not intended to be used to summon emergency care.
© Zensor
TM
Device 2019
www.zensordevice.com
PN 1414 Rev A
