J-Link Debugger
Quick Start
Stream it! - RZ solution kit
based on RZ/A1-LU
Reset
Switch
User LED
User
Switch
Potentiometer
USB0
Host
Power
LED
SD
Card
Ethernet
Port
Pmod
Header
Display
Connector
USB Power &
Serial
Console
Camera
Module (fitted)
1.
Installation
Do not connect the J-Link LITE debugger module until the software support has been installed.
1.
Insert the DVD into your computer. If you do not have a DVD drive, you can obtain the installation package from the
Renesas website.
2.
The DVD should auto-run, but if this is disabled, navigate to the root of the DVD and open the file “setup.hta”.
Note: This file is an html page known as the Web interface that allows launching of batch files. You can open the file
in a text editor to review the scripts.
3.
This page contains setup instructions and links to required tools; please install the tools if you do not already have
them installed.
Note:
Windows™ 10 / 8.1 / 8 / 7 users may see “User Account Control” dialog box. If applicable, enter the administrator
password and click ‘Yes’.
The Windows™ driver signing dialog box may be displayed. Please accept the driver to continue.
2. Connections
4.
To connect the camera:
a.
Lift up the dark brown flap on connector CN12 evenly.
b.
Slide the flex cable into the connector (make sure to insert it in the correct direction; see photo above).
c.
Push the flap down again to secure the camera module.
d.
Remove the plastic cover from the camera lens.
5.
Connect the J-Link LITE to the Stream it! board’s JTAG connector and then to your PC.
6.
Connect the Ethernet cable from the Stream it! board’s RJ45 connector to your network.
Содержание Stream it
Страница 4: ......
