RL78/I1A
Chapter 8 Applilet EZ for HCD Controller
On the
Lighting Communication Master Evaluation Board
, please confirm that
SW4 is set to “RUN“ and SW3 is set to “DMX”.
<7>
Connect the
Lighting Communication Master Evaluation Board
(EZ-0008), via the
DMX connector J1, with the
RL78/I1A DC/DC LED Control Evaluation Board
(acting as a DMX512 slave board), via the DMX connector CN3, using the three
wires provided.
<8>
Connect the
Lighting Communication Master Evaluation Board
to the host PC
using a USB cable.
<9>
Plug the DC 5V power supply cable to the
RL78/I1A DC/DC LED Control
Evaluation Board
via connector CN1.
<10>
Send DMX512 commands to the
RL78/I1A DC/DC LED Control Evaluation Board
using the DMX512 Master Controller GUI.
<11>
To find details about the DMX512 Master Controller GUI, please refer to the
corresponding User’s Manual (U19596EJ1V0UM00) that can be downloaded
from the Renesas Electronics website.
Note
8.6 DALI Dimmer Program
This sample shows how to set up Applilet EZ to program the DALI (Digital
Addressable Lighting Interface) stack into the R5F107DEG assembled to the
RL78/I1A DC/DC LED Control Evaluation Board
.
Make sure that you have set all the settings as explained in the
8.1 General
Settings
section.
<1>
Save the new Applilet EZ project (.hcd file). Select the
File
menu, then click on
Save As…
or simply click on the “
Save
” button, and input “
dali.hcd
” for example.
To finish click
Save
.
<2>
We now have a new Applilet EZ project file and we will change the dimmer
program to DALI.
<3>
Applilet EZ for HCD Controller Dimmer Program Selection (DALI)
Figure 35:
R01UH0363EJ0100 Rev. 1.00
32
March 23, 2012
