RL78/I1A
Chapter 8 Applilet EZ for HCD Controller
Repeat the same process for the two other channels. Then click on the
OK
button to exit the variable dimmer control window.
<6>
Applilet EZ for HCD Controller Wave Editor (3 channels)
Figure 30:
Make sure that SW2 dip switch of the
RL78/I1A DC/DC LED Control Evaluation
Board
is in flash programming mode, and that the USB and power supply cables
are connected correctly. Click the
“Save”
button and then the
“All P.”
button.
After downloading the application, please disconnect the USB and power supply
cables and set the board to the normal operation mode.
<7>
Plug again the DC 5V power supply, and you should now see the on-board LEDs
running the variable dimming application based on the above wave form.
<8>
8.4 Analog Input Dimmer Program
This program sets the duty value for each channel according to the on-board
variable resistors values read from the A/D converter.
Make sure that you have set all the settings as explained in the
8.1 General
Settings
section.
<1>
R01UH0363EJ0100 Rev. 1.00
29
March 23, 2012
