Renesas QB-RL78G13, Руководство пользователя

Страница: 22 / 26

QB-RL78G13 In-Circuit Emulator CHAPTER 2 SETUP PROCEDURE
2.1 Software Settings
Check the user's manual for the debugger that will be used.
2.2 Clock Settings
The IECUBE clock must be set to the clock used by the target device. For details about how to set the clock, check the
user's manual for the debugger that will be used.
IECUBE clock settings for the clock used by the target device are shown below.
Oscillation with the resonator on the target system is not supported. Therefore, the in-circuit emulator cannot emulate
the oscillation operation of the clock on the target system.
Table 2-1. List of clock settings
Clock Used Clock Supply
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the
target system
(1) High-speed system clock
(X1 oscillator or External input)
(c) When the oscillator (OSC1) mounted onto the emulator
is used
(2) Internal high-speed
oscillation clock
Uses the clock internally generated from the emulator
(3) Internal low-speed
oscillation clock
Uses the clock internally generated from the emulator
(a) When the clock generated within the emulator is used (4) Subsystem clock
(XT1 oscillator or External
input)
(b) When the clock (a square wave) is supplied from the
target system
R20UT0764EJ0200 Rev.2.00 Page 21 of 44
2012.03.30