How to Take Care of Your Air Mag. M.W. II
Storage
Keep the equipment in a dry place with as little temperature variation as possible. Try to protect from dust and always unplug
when not in use (if applicable).
Troubleshooting
If you are having problems with your heart rate reading please note that some fibres used in clothes eg) polyester, create static
electricity that may prevent a reliable heart rate reading. Mobile phones, TV’s, microwaves and other electrical appliances that
generate an electromagnetic field may also interfere with heart rate measurement.
If you are still having problems with your equipment, please get in touch with your local distributor using the details found in
the Customer Support section on page 4.
Cleaning & Maintenance
Your Air Mag M.W. is designed for indoor skiing used only and should not be used or stored in damp area.
Ensure you regularly check components for wear and make sure all the nuts & bolts are tightened before each exercise session.
Pulling Cords
– Clean daily before use.
•
Check for nicks or cuts and fraying that may weaken the pulling cords’ integrity even though it is made of superior quality
Tetoron webbing fabric to make it extremely strong.
•
Also check if the bushing at the handle end is intact. Use a warm, damp cloth to clean the whole surface of the pulling cords
after every exercise if possible.
Check and Replace the
Console AA Battery
–
Approximately every 200 hours if equipped.
Check for loose
Console Arm
–
Approximately every month.
Clean for Dusts on
Fan Wheel Assembly
–
Approximately every month.
Rear Carriage Rollers
– Clean daily before use.
•
These rollers ( bearings ) smooth moving will be affected by dust & dirt, so should be check
and clean regularly before use if possible.
•
Use a warm, damp cloth to clean the roller contact area with mild detergent if required.
•
Please lubricate the roller contact surface by applying slight of the ” multi-purpose grease “ if necessary.
Upright Post
– Clean & check daily after use.
•
Use a warm, damp cloth or non-abrasive pad to clean the surface with mild detergent if required.
•
Pay special attention on the both outside areas – remove any spots or dirt on it.
•
Please lubricate the rollers’ contact surface by applying slight of the ” multi-purpose grease “ if necessary.
Never remove the protective casing.
!
If you have a problem with your equipment, before you do anything else please check that all
the cables have been connected correctly. Loose cables are very common and many problems
can be solved by making sure the cables are properly connected
!
Discontinue use immediately and contact your dealer for replacement if any of the symptoms are found.
!
13
