Rendamax E8.1121, Руководство по эксплуатации, Страница: 14 / 44

Operation
Overview of display values and settings
Hot water
RATED DHW-T Current hot water set temperature according to
heating program and operating mode
DHW-TEMP Current hot water temperature
T-DHW LOWER Current temperature of HW tank in the lower
section (charge-through)
RETURN
Exit level using
Ä
!
Display only appears if the sensor
is connected and the value is
present in the system.
If the set value is not present it is
masked out, or hyphens appear in
the display (- - - -).
T-DHW LOWER
Temperature at lower hot water tank
sensor. The value is only displayed if
the value "CHARGE-THROUGH" is
activated at the level EXPERT =>
HOT WATER.
Heating circuit I / II
DES ROOMTEMP Current room set temperature according to
heating program and operating mode
ROOMTEMP Current room temperature
RATED POOL-T *) Swimming pool temperature setting
POOL-TEMP *) Current swimming pool temperature
HUMIDITY ***) Current relative humidity
RATED DHW-T **) Hot water temperature setting
DHW-TEMP **) Current hot water temperature
RATED T-FLOW Current flow temperature setting
FLOW TEMP Current flow temperature
N-OPT-TIME Previous time required to heat up
with heat-up optimisation activated
RETURN Exit level using
Ä
DES ROOMTEMP
If an operator device is connected,
there is no display
(“- - - -") in the controller => Value is
displayed in the operator device
ROOMTEMP (room temperature)
Only if a sensor or an FBR is
connected.
*) These values only appear if the
heating circuit is programmed for
regulating a pool.
**) These values only appear if the
heating circuit is programmed as
a hot water circuit.
***) This value is only displayed if an
operator device is connected and
the parameters have been set for
the corresponding heating circuit.
“- - - -„ => no humidity sensor
available in operator device
14