MR18 F3R
Engine user manual V03, February 2021 Page
25
sur
29
8.4 Oil filter replacement procedure
Use exclusively oil filter P/N: 1520865F0B.
- Clean carefully the oil filter area prior to remove the old one.
- Remove old oil filter.
- Apply a small amount of oil on the seal of the new oil filter.
- Assemble the oil filter and torque it at
20Nm
. Verify minimum 3 times the torque (filter shouldn’t
move) and mark its final position with a paint pencil.
8.5 Clutch tightening procedure:
- Read and carefully follow the Sachs instructions enclosed in the clutch box.
- Apply Loctite 243 and torque clutch nuts at
22Nm
.
DON’T FORGET TO REMOVE THE INSTALLATION CLIP!
8.6 Fly wheel tightening procedure:
- It is recommended not to use the flywheel screws several times.
- Before tightening, apply copper grease or ARP grease on the thread and on the underside of the
screw head and torque fly wheel screw at
90 Nm.
