Renault KlGER, Руководство пользователя транспортного средства, Страница: 98 / 226

2.20
AUTOMATED MANUAL TRANSMISSION (3/4)
Creeping
It is a function that enables the vehicle
to move slowly without pressing accel-
erator pedal.Follow the steps:
– Start the engine as instructed in
“Starting the engine”section.
– With brake pedal pressed, shift the
lever to D position.
– Release the parking brake and brake
pedal to activate creeping.
Driving in manual mode
This mode can be activated at any time
when driving by pushing the lever to po-
sition M .
To shift up a gear, simply push the se-
lector lever backwards without neces-
sarily releasing the accelerator.
To shift down a gear, simply push the
selector lever forwards without neces-
sarily releasing the accelerator.
The system will not tolerate a series
of up or down changes that cause the
engine to underrev or overrev.
By pushing the lever backwards twice,
you can move up two gears at a time
(except if under-revving). By pushing
the lever forwards twice, you can move
down two gears at a time (except if
over-revving).
When decelerating with the foot off the
pedal, the gears will automatically drop
to the low engine speed limit to avoid
stalling. The vehicle may be kept sta-
tionary (stop, red light etc.) by depress-
ing the brake pedal without shifting into
neutral N .
The vehicle will move off again:
– either slowly, if you release the brake
without accelerating (e.g. when in a
traffic jam),
– or quickly, if you release the brake
and accelerate.
Note: Neutral N may only be selected
when the vehicle is being driven or is
stationary or without touching the brake
pedal.
If the engine speed is too high or too
low, the system will choose the opti-
mum gear.
Manual mode can be deactivated and
reactivated at any time with the engine
running by moving the lever to position
D and respectively to M .
Exactly like a vehicle
equipped with a manual
gearbox, a vehicle equipped
with a sequential gearbox is
unable to prevent the vehicle from
rolling on a slope if the handbrake is
not applied or the brake pedal con-
stantly not pressed. The vehicle can
be in stationary place on an incline
for 2 seconds (Giving Driver enough
time to take his foot off the brake &
press the accelerator)