6 | 16
M0698.docx |
Rev 2.3 | Modified on 29/09/2017
| © Remote Control Technologies Pty Ltd
CONTROLLER STATUS INDICATOR OPERATION
STATE
INDICATOR SEQUENCE
Battery Power-up
■
All indicators will turn on.
■
All indicators will turn off.
■
After power-up, the controller will revert to normal operation.
Status Indicator in
Operation
RED
– Fault.
■
If outputs have problems, this will turn on.
■
Outputs 1 & 2 – high current outputs: checked for over current.
■
Output 3 – not checked as it is a low side driver.
■
Output 4 – checked for correct output voltage.
■
Temperature – checked for board temperature exceeding 80 °C.
YELLOW
– Pulses during normal operation, indicates system OK.
■
Flashes on and off at one-second intervals (on for one second, off for
one second).
GREEN
– On for normal operation.
■
Flashes when valid input goes active (number of flashes = input number).
■
Allows checking that inputs are correctly wired and that the hardware is
seeing the input toggle.
Alarm Indication
System Status
Power Indication
