4 | 16
M0698.docx |
Rev 2.3 | Modified on 29/09/2017
| © Remote Control Technologies Pty Ltd
GENERAL SAFETY WARNINGS
PERSONAL SAFETY
■
Everyone is responsible for safety.
■
The installer/service personnel should be trained and authorized to complete the required work.
■
Ensure that the machine is safely isolated during installation and testing to protect all personnel.
■
Complete all required risk assessments and job safety analysis (JSA) before commencing work.
■
Observe all site specific and machine OEM procedures regarding the following:
–
working at heights
–
working in heat
–
working in confined spaces
–
all other site specific occupational health and safety (OH&S) procedures
MACHINE
■
Carry out all prestart operations as per site and machine OEM procedures.
■
Ensure the machine is safely isolated during installation and testing to protect the machine and other
equipment in the area.
■
Do not operate any machine with a known fault and report all findings to the supervisor in writing.
■
Test and operate machine as per machine OEM and site procedures.
■
Read and understand machine and site specific operational and testing instructions.
PRODUCT
Before applying power to the equipment, the user/repairer/ installer must read all product instructions. If in
doubt, seek assistance.
■
Ensure electrical connections are made as per RCT’s recommendations. Test circuits prior to connecting
power to any component.
■
The equipment contains no user serviceable parts inside. Return the unit to RCT for repairs.
■
Retain product and installation instructions for future use.
■
Ensure that RCT’s recommended service procedures are included in the machine’s service routine.
■
Observe all machine, site and RCT product warnings.
■
Follow all machine, site and RCT product operating procedures at all time.
The application of safety should not be limited to the above recommendations.
