P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
TX-3v2
Digital Proportional R/C
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Preparing the TX-3v2. Binding.
Page # 3 Preparing & driving Live Steam locos.
Page # 4 Using with a centre off battery R/C ESC.
Other instructions for use with battery R/C are
found with the ESC.
http://www.rcs-rc.com/pages/instructions
Thank you for purchasing this DSM2 3 channel TX handpiece.
THE PRIMARY PURPOSE OF THE TX-3 IS FOR CONTROLLING LIVE STEAM LOCOS.
THE SECONDARY PURPOSE IS FOR USE WITH “LOW OFF” RCS BATTERY ESC’s.
THE TX-3 CAN ALSO BE USED WITH ANY “CENTRE OFF” ESC’s.
INSTRUCTION MANUAL
THESE INSTRUCTIONS REFER SPECIFICALLY TO THE
DELTANG R/C
BASED TX-3 HANDPIECE.
They should be read in conjunction with the RCS ESC you are using.
WHEN USED FOR LIVE STEAM A
SMALL KNOB SETS THE VALVE GEAR.
300º KNOB CONTROL OF REGULATOR.
1 X FULL THROW SERVO FOR WHISTLE.
REMOVE REAR OF TX-3 TO INSERT
THE 9 VOLT BATTERY.
LED BLINKS WHEN BATTERY LOW.
A HIGH QUALITY 9V SNAP IS USED.
WHEN USED FOR BATTERY R/C
SMALL KNOB SETS THE DIRECTION.
300º KNOB CONTROLS SPEED.
1 X BUTTON FOR SOUND TRIGGER.
PRIMARY USE IS WITH LIVE STEAM LOCOS.
CAN ALSO BE USED WITH RCS BASIC “LOW OFF” & “CENTRE OFF” ESC’s.
THE TX-3v2 IS GUARANTEED FOR ONE YEAR.
When used for battery R/C you will supply a locomotive or trail car, the 14 – 20 volt traction batteries (depending on ESC), a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
TO AVOID CONFUSION WITH OTHER OPERATORS, WE SUGGEST YOU MARK THE TX TO
SHOW WHICH LOCO IT IS OPERATING.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
