REMKO KNGcooling module, Руководство по установке

Страница: 13 / 24

Removing the actuator
Proceed as follows to replace the actuator:
1. Pull the safety split pin below the actuator out
so that the actuator can be removed [1].
2. Pull the actuator away from the valve body
[2].
1
2
VA
LVE
ACTU
AT
OR
ASSEMBLING
3. Re-install the new drive in reverse order.
In order to replace the entire changeover valve, the
hydraulic connection for the valve [1] that is to be
replaced must be closed and bled accordingly.
After bleeding, you can loosen the three valve [1]
screw connections. After replacing one or both
valves [1], ensure that no air bubbles have formed
in the heat exchanger [2]. If there is air in the heat
exchanger [2], this can be bled manually via the
connections [3] in the upper part of the cooling
module for both sides. All screw connections must
be checked after replacing.
3
B
AB
A12
A B
AB
A
S 13
A12
3
2
1 1
13