REMKO ETR 1-10, Инструкции по эксплуатации и монтажу, Страница: 11 / 16

SP-H: Upper setpoint limit
Determination of the maximum adjustable setpoint
-15°C to 99.9°C in 0.1°C steps
Attention: The setting value of the lower setpoint
limit must not be higher than the setting value of
the upper setpoint limit and vice versa!
Ag.t: Time for averaging
Time setting for the period of time in seconds used
for the formation of an average value of the current
temperature (fast or slow regulation response) 0s
to 999s in 1s steps.
5 Installation
The electronic temperature controller is suitable for
wall mounting with a surface-mounted cable inlet.
If an external probe is used, please observe the
following instructions.
NOTICE!
Assembly and maintenance work on the ther-
mostats may only be carried out by authorised
and qualified technicians.
The external temperature probe must, where
possible, be fitted to an internal wall around 1.5
m above the floor.
The external temperature probe must be
installed such that it can record the average
room temperature. Draught and proximity to
windows, doors and heat sources, etc. must be
avoided.
The thermostats must be installed in such a
way that they are easily accessible for moni-
toring, maintenance and repair work.
1 2
Fig. 4: Probe installation
1: Do not fit probe next to windows!
2: Do not fit probe in hot air flow!
11