ReliOn SS2280, Руководство пользователя

Страница: 70 / 83

Cable Connections
1230B0033901 4-2
4.2 Cable Connections
You can get a clear picture on how to connect the cables from the figures below.
Before connecting cables you must make sure there are no bent pins existing because it
affects signal transmission. With the pin 1 location and foolproof feature, you can link these
cables correctly and conveniently. There are two ways for you to judge how to connect the
cables:
1. When there is no foolproof feature on this connector, you should connect the red margin of
the cable to the pin 1 location on the connector.
2. When there is a foolproof feature on the connector, you can connect the cable according to
the foolproof feature.
This section contains figures showing cable locations and descriptions of the connection
procedures. This section shows all the cable connections associated with the server.
4.2.1 JBOD Cable
This server is designed with SAS JBOD as the picture shown below. These connectors are
used to connect to the daughter card and external device. The detailed connection method is
listed as follows:
For SAS JBOD, is used to connect to the external devices; is used to connect to
the daughter cards.
Figure 4-2 JBOD Introduction
For the detailed information about the connector on the backplane as the
picture shown below, please refer to “3.8 SATA&SAS Backplane”.
For the description of daughter card, please refer to “3.11 Daughter Card.