REITER Respiro R9 profi, Руководство по эксплуатации

Страница: 46 / 74

42
6. Getting started
Attach the machine to the rear linkage, raise the supporting leg and secure it with the bolt.
Connect the hydraulic lines and brake lines.
Connect the main electrical wiring harness and attach the control terminal to the power
supply.
Perform the following activities carefully:
1. Check all connectors for perfect bond: main connector, power supply, hydraulic hose
and brake lines
2. Unfold machine as described earlier.
3. Try to raise and lower the working units
4. Start the oil flow via the PTO shaft
5. Increase the working speed of pick- up and rotor by pressing the “+” button
6. Try to run the band left and right. Check the belt speed control.
7. Increase and decrease the distance between the working units
8. Lift the Rotor and lower it again
9. Check floating position of rotor and telescopic frame
Checks before use:
If the oil level drops too low, the return oil can splash on the surfaces => foam => axial piston
pump and subsequently all other hydraulic motors will be damaged!!!
If you notice a nagging noise on the axial piston pumps, immediately switch off the PTO and
contact customer service.
1. Check frame flange fittings for tightness.
2. Check wheel nuts for all four wheels for tight fit
3. Check all bolt connections and hydraulic cylinders.
1. Check the oil level: if the pto shaft is
approximately horizontal and the oil
temperature is approx. 20 ° C, the oil
level in the upper window must be
visible.
If this is not the case, top up with hydraulic oil
HLP 46.
Safety indicator Oil level at the terminal: