REITER Respiro R9 profi, Руководство по эксплуатации

Страница: 26 / 74

22
4. Mounting and dismounting of Respiro R9
Attention: Never exceed the permissible total weight of the tractor, its maximum lifting capacity and
the maximum permissible axle loads!
4.1. Requirements for the tug hydraulics:
•
2x double acting control units with floating position
•
Load Sensing
•
Standard rear linkage
•
ISOBUS connector
•
7 – pin connector
•
Two air brake connectors
Description of mounting elements:
•
PTO shaft to drive axial piston pumps
•
ISOBUS cable
•
7 – pin cable
•
4 hydraulic flexibles
•
Three load sensing lines
•
Two pressure air lines for braking device
4.2. Coupling of the machine
Important: always mount or dismantle the machine in the same condition of folding on the
tractor. This ensures that the hydraulic oil level in the tractor remains unchanged. If this is
not observed, there will be a lack of oil or oil overflow in the tractor.
4.2.1. Coupling of the lower link
For coupling you need lower links and lower link balls of category 3.
The lifting struts of the tractor three-point linkage should be aligned so that the lower links are
aligned parallel to the ground.
After decoupling, raise the lower links and push the strut upwards.