INSTRUCTION
i
Read this instruction before installation
and wiring of the product.
To see if your country is eligible for the use of this
product, please refer to the document
List of supported
countries CLO-3G
on the CLO-3G page on our website.
CLO-3G
1
3G modem
CLO-3G functions as a gateway to connect one Corrigo with integrat-
ed web server to Regin’s cloud service CLOUDigo via a mobile 3G/
GPRS network. CLO-3G has a built-in DHCP function that handles
connecting to a Corrigo. Upon delivery, CLO-3G is pre-set to connect
to CLOUDigo using the factory-installed SIM card. No settings need
to be performed to the modem.
Technical data
Supply voltage
24 V AC or DC ± 10 %,
50...60 Hz, 200mA
Connections
Ethernet
RJ45, crossover network cable
Antenna
SMA-F contact
Communication
LAN
TCP/IP, DHCP
Mobile network
3G global 850/800, 900, 1900, 2100 MHz
GSM/GPRS global 850, 900, 1800,
1900 MHz
Ambient temperature
-30…+60°C
DHCP (non-configurable)
Gateway IP
192.168.0.1
Indications
The unit is equipped with one yellow and one red/green LED.
Red/green LED
Mobile network connection
Flashing red light
Searching for mobile network
Steady green light
Good reception
Steady red light
Weak reception
No light
Very weak or no reception
Yellow LED
TCP connection and activity
Fixed yellow light
The unit is connected to CLOUDigo
Flashing yellow light
Sending data
Settings
Upon delivery, CLO-3G is factory set to connect to the CLOUDigo web
page. When the unit is to be used for this purpose, no additional settings
are necessary.
CLO-3G cannot be connected to several Corrigos at the same time.
Changing the settings of the connected unit
CLO-3G is a DHCP server, distributing an IP address to the connected
controller. It is therefore important that the connected unit be configured to
obtain its IP address from a DHCP server before being connected to the
modem. This is performed using E tool
©
(please refer to chapter 11.3 of
the E tool
©
manual).
It is also necessary to set up the Corrigo so that it connects to CLOUDigo.
For more information, please refer to chapter 13 of the E tool
©
manual.
The Corrigo serial number
When a new Corrigo is registered in CLOUDigo, it is necessary to enter
the serial number of the controller. Therefore, ensure that the number is
written down, so that it can be entered into CLOUDigo later.
LVD, Low Voltage Directive
This product conforms to the requirements of the European Low
Voltage Directive (LVD) 2006/95/EC through product standards
EN 60730-1 and EN 60730-2-9.
EMC emission and immunity standard
This product conforms to the requirements of the EMC Direc-
tive 2004/108/EC through product standards EN 61000-6-1 and
EN 61000-6-3.
RoHS
This product conforms to the Directive 2011/65/EU of the European
Parliament and of the Council.
Contact
AB Regin, Box 116, 428 22 Kållered, Sweden
Tel: +46 31 720 02 00, Fax: +46 31 720 02 50
www.regincontrols.com, [email protected]
CLO-3G
EN
11072D
DEC 14
