Regency H200, Инструкция для владельца и по установке

Страница: 24 / 44

24
|
Hampton® H200 Cast Freestanding Woodstove
|
24
operating instructions
SAFETY GUIDELINES AND
WARNINGS
1) Never use gasoline, gasoline type lantern
fuels, kerosene, charcoal lighter fuel, or
similar liquids to start or ‘freshen up’ a fire
in your heater. Keep all such liquids well
away from the heater while it is in use.
2) Keep the door closed during operation and
maintain all seals in good condition.
3) Do not burn any quantities of paper, garbage,
and never burn flammable fluids such as
gasoline, naptha or engine oil in your stove.
4)
If you have smoke detectors, prevent smoke
spillage as this may set off a false alarm.
5) Do not overfire heater . Attempts to achieve
heat output rates that exceed heater design
specifications can result in permanent dam -
age to the heater. If the chimney connector,
flue baffle or the stove top begin to glow, you
are overfiring. Stop adding fuel and close the
draft control. Overfiring can cause extensive
damage to your stove including warpage
and premature steel corrosion. Overfiring
will void your warranty.
6) Do not permit creosote or soot build-up
in the chimney system. Check and clean
chimney at regular intervals. Failure to do
so can result in a serious chimney fire.
7) Your Hampton stove can be very hot. You
may be seriously burned if you touch the
stove while it is operating, keep children,
clothing and furniture away. Warn children
of the burn hazard.
8)
The stove consumes air while operating,
provide adequate ventilation with an air
duct or open a window while the stove is in
use.
9)
Do not connect this unit to a chimney flue
serving another appliance.
10) Do not use grates or andirons or other
methods for supporting fuel. Burn directly
on the bricks.
11) Open the draft control fully for 10 to 15
seconds prior to slowly opening the door
when refuelling the fire.
12) Do not connect your unit to any air distribu-
tion duct.
13) Your woodstove should burn dry, standard
firewood only. The use of cut lumber, ply -
wood, “mill ends”, etc. is not allowed as this
fuel can easily overheat your woodstove.
Evidence of excessive overheating will void
your warranty. As well, a large portion of
sawmill waste is chemically treated lumber,
which is illegal to burn in many areas. Salt
drift wood and chemically treated fire logs
also must not be burned in your woodstoves.
14) Do not store any fuel closer than 2 feet
from your unit. Do not place wood, paper,
furniture, drapes or other combustibles near
the appliance.
15) WARNING: Do not operate without
the Ash Plug properly seated.
16) Do not operate with broken glass.
DRAFT CONTROL
Both the primary and air wash drafts are control -
led by the control handle located on the right side
of the unit (when facing the unit). To increase your
draft - push lever to the back, and to decrease -
pull lever to the front. All units have a secondary
draft system that continually allows combustion
air to the induction ports at the bottom of the
firebox, just below the rear cover.
WARNING: To build a fire with disregard
to the information contained in this
section can cause serious permanent
damage to the unit and void your war -
ranty.
Front - Closed Back - Open