Reflex Marine FROG-6 HC6-01 620, Руководство пользователя, Страница: 43 / 97

User Manual FROG-6
UM-0007-REV.06 Page 43
Item
No Description Comment Pass /
Fail Verified
By
7. Seat Base Assembly and the Hydraulic Damper and Anti-Tilt Assembly
Visually inspect and test all fixings for any wear or dam age and ensure that all bolts, clevis’ and other fasteners are
fully secure. Ensure that the damper rod-end threads are not visible below the clevis pin eye. (see Technical
Bulletin 01-09 at
http://www.reflexmarine.com/index.cfm/p/Technical-Safety-Alerts ).
8. Landing Feet - Examine the feet to ensure that they are in good condition and that they are properly secured to the
capsule. Do not go underneath an active lift. Notes:
i. Measure height of foot and replace if under 150 mm in height
ii. Small (20 mm in length) cuts are acceptable but feet should be replaced when the internal foam
becomes visible
9. Frame and Buoyancy - Visually inspect for any damage and ensure that all bolts and fasteners are tight and fully
secure.
10. Seat Harness Security (Critical Part) - Visually inspect the seat harness attachment points and the harness webbing
for any signs of wear, fraying or damage. Check that attachment points are secure.
11. Seat Harnesses (sit-in) - Check all seat harness buckles to ensure each is functioning correctly. (Inspector to sit in
each seat and check fastening and unfastening of each harness).
12. Load Test (see Section 6.8 ) - On critical parts replacement, a load test (see Table 3 in Section 6.3) must be
conducted. This is to be done by an independent test house company, nationally recognised and in accordance with
ILO 152.
13. Inspection data plate - Update the inspection data plate after completion of approved Examination/inspection
14 Post Load Test Visual Inspection (See Section 6.7 ) – If test is done, conduct and report a post load test visual
inspection.
Storage
15. Storage of FROG - Check the storage cover is in good condition and not showing any signs of UV or wind
degradation.
Storage off the ground , use of spacer chocks whilst not in use
16. Replacement Parts Stock - Check condition of all associated replacement parts and accessories. Sling sets should be
stored in an appropriate dry place without high visibility cover fitted.