Torque Wrench Kit TW-8
Item no.: 4666034, TW-8
How to set a certain torque:
1. Loosen the locking nut at the bottom of the handle.
2. Determine a desired torque.
3. The engraved numbers on the drum show 0, 10, 18 and 42. The
engraved numbers on the shaft show 10, 18, 42, 55, 65 and 75.
You can set your torque anywhere between 10 and 75 Nm.
Example torque setting at 44 Nm
1. Turn the handle clockwise and until the engraved line 42 on the
handle is aligned with the middle line on the shaft and the top
edge is aligned at the same time with the offset line of the 42
marker on the shaft.
2. Turn another two lines with the handle clockwise. The torque is
now set at 44 Nm. Lock the nut at the bottom of the handle.
Example torque setting at 56 Nm
1. Turn the handle clockwise and until the engraved line 42 on the
handle is aligned with the middle line on the shaft and the top
edge is aligned at the same time with the offset line of the 42
marker on the shaft.
2. Keep turning clockwise by counting each marker that passes
the middle line of the shaft until you reach 56 Nm. The edge of
the handle is now slightly above the 55 Nm offset marker line of
the shaft.
NOTE: Only use the torque wrench in the direction of the arrow
engraved on the top of the shaft.
