Reely ROAD Carbon Fighter, Руководство по эксплуатации

Страница: 41 / 118

39
e) Connecting the Driving Battery to the Speed Controller
First switch off the speed controller. Put the On/
Off switch (see figure to the right) into the "OFF"
position for this.
Then switch on the transmitter (see chapter 8. b)
and c).
To prevent a sudden starting of the wheels and therefore an uncontrolled starting of the model (e.g. if the
trimming for the drive is maladjusted), place the model vehicle on a suitable surface (or starting box), so
that the wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels
Now connect the driving battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-).
f) Switching on the Speed Controller
Put the on/off switch of the speed controller (see chapter 8. e)) into the “ON“ position. Then wait for a few seconds
(leave the throttle/brake lever on the transmitter in the neutral position; do not move it).
If the drive of the vehicle starts although the throttle/brake on the transmitter is in the neutral position, then
adjust the trim on the transmitter until the engine stops. If the trimming path is insufficient, the neutral
position must be programmed, see chapter 10. a).
Now check the drive and steering function of the vehicle.
For programming the speed controller, please observe chapter 10.
Important!
If a LiPo battery is used as a driving battery, the undervoltage protection has to be activated
before the vehicle is driven for the first time.
Otherwise, a LiPo battery may be subject to deep discharge, which will damage it.