LIMITED WARRANTY
Reelcraft affirms its product confidence with the following
warranty.
All products manufactured by Reelcraft Industries, Inc. are
warranted to be free of defects in material and workmanship for
12 months from the date of shipment,
except hose.
Reelcraft's
liability shall be limited to repair or replacement of defective
material within the warranty period when returned freight prepaid
to its plant or to a service depot designated by Reelcraft.
The warranty does not cover damage caused by accident,
abuse or faulty installation. Reelcraft products must be in-
stalled and maintained in compliance with the manual of
instructions furnished with each reel.
Hose latching mechanism can be removed for constant tension applications.
OPERATING INSTRUCTIONS & PARTS LIST
HOSE REEL
SERIES E9000-LOW PRESSURE
Models designed for fuel are coded with the prefix "F"
i.e., "FE9400 OLP." Check name plate on the reel
before installing.
Do not use reel at higher pressures or temperatures than
listed on the back of this bulletin.
Remove all spring tension before beginning dissassembly
process.
Reel spring motor case is permanently sealed. Any
attempt to remove the spring motor may cause serious
injury.
III.
IV.
I.
II.
SAFETY
REELCRAFT INDUSTRIES, INC.
P.O. Box 248
One Reelcraft Center
Columbia City, Indiana 46725
260-248-8188
1-800-444-3134
Fax: 260-248-2605
FE9500 OLPBW
FE9600 OLPBW
MODEL NUMBERS
Form# 775-595
Rev: 6/02
A
B
C
D
E
F
G
H
J
K
26 ¼"
26 ¼"
13 ¾"
12
1
/
8
"
24 ¼"
22
1
/
8
"
24 ½"
17 ½"
13 ½"
7 ½"
Four 7/16" Mounting Holes
Modification:
Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which
may void your warranty. Remove all spring tension before beginning disassembly process.
Repairs:
To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired
tension is obtained.
Adjustments:
Replacing Hose:
1. Wind spool flange clockwise-facing swivel-until spring is tight.
2.
Back off three turns and latch.
3. Insert hose through roller guide.
4. Connect hose fitting to female outlet ell.
Hose reel spring is permanently sealed and requires no further lubrication. Bearings fitted with grease zerts
require periodic lubrication as required.
Lubrication:
The swivel union is packed separately in the reel carton, use teflon tape to assure a satisfactory seal. A
flexible connection between the reel and the source of supply is required. Nonflexible connections
will void the warranty, pressure rating of inlet hose must be equal or more than the pressure rating of
the reel. Consult factory for proper spring when installing reels above 16 ft.
Mounting:
A flexible hose connection must be used between the hose reel inlet and source of supply to prevent
possible misalignment and binding.
I
nstallation:
INSTRUCTIONS
