Install the two XHO's included with the XHO-K15 kit with the screws provided on the
ends of the XHO's.
Using the supplied 2-way connector plug in each of the two XHO's.
Attach the supplied power supply in your XHO-K15 kit to 2-way connector.
When plugging in the Y connector to the XHO's or power supply to the 2-way connector,
make sure to insert plugs
until you feel them lock in place.
Make sure to locate the power supply in a safe location away from any
contact with water.
Carefully attach your fixture to the aquarium mount, plug in fixture and power supply to
a
GFI outlet (Recommended)
assuring a proper drip loop is employed.
Important note: Use of power strips located on floors or any location
where water can come in direct contact with them is dangerous and can
cause serious injury or fire. Make sure all electrical plugs and electrical
outlets are safely located so that water cannot splash or spill on them.
Installation instructions for hanging kits:
When working around water make sure all working surfaces are completely dry before
handling any electrical equipment.
Make sure your fixture is unplugged from electrical outlet and
disconnected from the power supply before attempting to install the XHO-
K15 kit.
If fixture was in use even for just a short period let cool.
LED’s can get very hot
during operation and can cause personal injury or damage surfaces if
proper care in handling is not taken.
Once cool, place fixture on a secure table or work surface.
Locate the hardware that came with your hanging kit.
Attach the two brackets that came with your XHO-K15 kit by placing them over the
top
of the fixture, so that the holes in the XHO-K15 brackets align with the threaded holes
on your fixture.
Using the supplied hardware that came with your hanging kit attach the hanging kit and
brackets to your fixture.
