PAGE 1
Installation and Operation Instructions -
Tornado Microbar AutoDIM
V1 (M111)
+44 (0)1422 310999
WWW.REDTRONIC.CO.UK
Step 1
MANUFACTURED IN THE
UNITED KINGDOM
Ensure Microbar is powered off. Remove 6off
M5 x 10mm screws from Microbar lens using
crosshead screwdriver.
Step 2
Step 3
Remove 4off M4 x 8mm screws and anti
vibration washers from Microbar PCB using
3mm hexagonal key.
Remove Microbar Lens. Ensure that the O-ring
remains in position in the sealing groove.
Step 4
Remove PCB from microbar base. Handle with
care, ensuring power lead connections remain
in place.
Step 5
Step 6
Plug autoDIM module into 4-pin connector on
underside of Microbar PCB.
Assemble M3 x 8mm standoffs with auto
DIM module using M3 nuts and anti-vibration
washers
