Redline Communications RedMAX AN100U, Руководство по администрированию и обслуживанию

Страница: 162 / 178

C-16
Redline Management Suite Administration and Maintenance Guide
Redline Communications Inc. Confidential and Proprietary
The following table lists messages that are rarely encountered during normal
operation.These messages are provided for information only. If you do encounter any of
the following messages contact support@redlinecommunications.com.
Unicast Initial Ranging Start
[CID: XXXX] The subscriber unit has received a
unicast ranging opportunity Redline sector controller’s never send unicast
ranging opportunities, but it is possible with other
vendors’ equipment. This is normal behaviour for
802.16 standards compliant devices.
Unicast Ranging Abort Indicates that the sector controller has
sent the subscriber unit a ranging
abort, telling it to halt the ranging
process. This indicates that the subscriber unit was unable
to adjust parameters as requested by the sector
controller. Most likely to be a Tx power or
frequency adjustment problem. Can indicate
either a path issue, or a bad SU
Uplink Channel Parameters
Acquired The subscriber unit has successfully
obtained the uplink channel descriptor This message is part of the normal registration
process.
Uplink SF nn changed Changes have been successfully
applied to the specified uplink service
flow. Information only. There is no action required.
Uplink SF nn created [CID:
XXXX, No.Cls: nn] An uplink service flow has been
successfully created. Information only. There is no action required.
Uplink SF nn not created (no
space) [CID: XXXX] The subscriber unit cannot create the
specified UL service flow, as there is
not enough remaining memory. This message should not normally be
encountered. Check the number of SF’s and
classifiers you have created per subscriber unit,
and verify that it is within Redline’s supported
limits.
Wrong RF module. Restart The subscriber unit cannot detect the
RF chip. It is rebooting in an attempt to
correct the issue.
Information only. There is no action required.
Table C-1 Subscriber Event Log Messages (continued)
Message Description Analysis
Table C-2 Additional Subscriber Event Log Messages
Message Description Analysis
***Failed to alloc initial RX buffer Developer Message
***Failed to alloc initial RX MPI structure Developer Message
***Failed to alloc initial RX seg. Chain Developer Message
***Failed to build DlMap RxMpdus Developer Message
***Failed to build DmMap RxMpdus (nn) Developer Message
***Failed to build Initial RxMpdus Developer Message
***Failed to build Last Burst Rx seg. Chain Developer Message
***Failed to build Last Burst RxBuffer Developer Message