Redline Communications AN-50e, Руководство пользователя

Страница: 38 / 100

AN-50e
user manual
70-00033-01-03 Proprietary Redline Communications © 2005 September 2005
Page 38 of 100
Management
Ethernet Mode : Select the operating mode of the Ethernet port (AN-50e only).
Auto - Auto-negotiate the speed connection speed.
10 - Operate at 100Base-T only.
100 - Operate at 100Base-T only.
HD - Operate at half-duplex only.
FD - Operate in full duplex only.
Note: This hardware-enabled feature is not available on the AN-50.
HTTP Enable : Check this box to enable the HTTP (Web) interface.
Telnet Enable : Check this box to enable a Telnet session. Refer to the CLI
commands in section 6.4: CLI Interface on page 86.
Telnet Port : Enter the Telnet port address. The default Telnet port is 23. The port
can be changed to any other number between 23 and 65,000, excluding port 80.
SNMP Enable : Check this box to enable the Simple Network Management
Protocol (SNMP) agent. When this item is checked, clicking on the blue text
'Configure SNMP' beside the check box displays the SNMP Configuration screen.
See section 3.8: SNMP Settings on page 49 for additional information on setting
up SNMP for the AN-50e.
Mgmt. Tag Enable : Check this box to enable VLAN tagged traffic.
The Mgmt Tag Enable setting is disabled (factory default) when shipped from the
factory or following a long-reset operation. In this mode the sector controller and
subscriber stations can be managed through the local Ethernet port using untagged
traffic. Over-the-air management is possible only after creating a pass-through
group and pass-through connections for each subscriber station.
Refer to section 66: Setting Up for Pass-Through on page 66 for step-by-step
instructions.
When Mgmt Tag Enable is enabled, this sector controller or subscriber station can
be managed only using VLAN traffic tagged with the value specified in the Mgmt.
VID field. Over-the-air management is possible only after creating a VLAN
tagged group and VLAN tagged connections for each subscriber station.
It is recommended to create and test a VLAN group for tagged management traffic
before activating the Mgmt Tag Enable function. Set the associated QoS and
priority values to ensure management traffic has adequate priority and bandwidth
during system operation.
Mgmt. VID : Enter the VLAN ID. When Mgmt. Tag Enable is selected, the system
recognizes only management commands with this VLAN ID.
Important : The VLAN network support should be verified before enabling this
feature to ensure the AN-50/AN-50e system will be reachable using the VLAN
tagged traffic.