Redlake MASD MegaPlus ES 4.0/E, Руководство пользователя

Страница: 23 / 40

Mega Plus
®
Model ES 4.0/E
3.4.23 Reset
This command allows you to recall saved (SAV) settings. RST 3, for example, recalls the settings
saved when you entered SAV 3.
TYPE IN: RESPONSE EXPLANATION
RST CR-LF Resets the camera to the settings as last saved in
the SAV command. Up to 10 operating states can
be recalled by inputting RST x, where x is the
operating state previously saved (0 – 9).
3.4.24 Display Wedge
The wedge command displays linearly increasing gray scales in each quadrant of the image as
shown in Figure 3-1. The wedge display is not perfectly linear. It contains OGC, DEF and LUT
values. The OGC and DEF values can be turned off by the user, but the LUT values cannot be
eliminated from the wedge display. In Pattern 1, the pixel value increments every pixel. In
Pattern 2, the pixel value increments every line. In Pattern 3, the pixel value increments every
frame. The display wedge defaults to OFF when the power to the camera is turned off.
TYPE IN: RESPONSE EXPLANATION
WDG ON
CR-LF Means the wedge is being displayed.
WDG OF
CR-LF Means the camera is imaging.
WDG 0-3 WDG x Selects one of the following:
0 = OF
1 = Pattern 1 ON
2 = Pattern 2 ON
3 = Pattern 3 ON
WDG? Queries the state of the wedge display.
Figure 3-1. Wedge Display Patterns
3.4.25 Smear Correction
This command enables or disables the smear correction feature of the camera. With this feature
enabled, the smear content of an image is calculated and then subtracted out of the image.
TYPE IN: RESPONSE EXPLANATION
SMC ON CR-LF Enables the smear correction feature.
SMC OF CR-LF Disables the smear correction feature.
SMC? Queries the current smear correction setting.
SMC xx Smear correction feature is set as indicated.
91000116-001 Revision B 3-9 USER’S MANUAL