To use the drop side function
1. Undo the zips, squeeze the buttons on both sides
and lower the rail until it locks in place. Figs 1a & 1b.
Thread the three straps under the mattress on to the
buckles and pull tight. Fig 1c
.
ATTENTION!
Do not force the zip all the way down.
It has been designed to stop here.
To use in bedside crib mode
2. Thread the fixing belt plate between the adult’s
mattress and pivot the plate so it lies flat against both
the bed base and mattress. Fig 2a. Connect the
ends of the fixing belts to the buckles on each end of
the cot (Fig 2b) and pull tight by adjusting the sliding
sliders. Ensure the cot is tight against the bed. Fig 2c.
Fig 1a.
Fig 1b.
Fig 1c.
Fig 2a.
Fig 2b.
Fig 2c.
Zip
Straps and buckles
Fixing
belt
plate
Fixing belt
Fixing belt
Slider
Buckle
Mattress
Bed base
Button
“CLICK”
Dreamer in bedside crib mode
WARNING!
Before every use always check to make sure there is no space between the parents
mattress and the side of the co sleeper.
If any space is found, pull the belts firmly to tighten until there is no space left and the correct position has been restored.
Only suitable for beds with straight sides.
Not suitable for beds with round mattresses or water beds.
When the product is used in the bedside sleeping mode, it should always be fitted to the
long side of the bed.
Do not fix the co sleeper to the head or bottom of the bed.
Never use the crib in co sleeping mode without the anchor plate.
Ensure the plates are securely attached to the adult bed.
Crib In Co Sleeper Mode:
DANGER! Always completely raise the drop side when not attached to the adult’s bed.
WARNING - To avoid the risk of your child being strangled the attachment system to the
adult’s bed shall always be kept away from and out of the crib.
• SUFFOCATION HAZARD - INFANTS HAVE SUFFOCATED IN GAPS BETWEEN EXTRA PADDING AND SIDE OF
BASSINET/CRADLE AND ON SOFT BEDDING.
• NEVER ADD A PILLOW, COMFORTER OR ANOTHER MATTRESS FOR PADDING.
• STRANGULATION/SUFFOCATION HAZARD: THE TOP EDGE OF THE LOWERING BAR MUST BE LEVEL WITH
OR BELOW THE TOP OF THE ADULT MATTRESS WHEN USED AS THE BEDSIDE SLEEPER. THE LEVEL OF THE
BEDSIDE SLEEPER BASSINET MATTRESS MUST BE A MINIMUM OF 10 CM BELOW THE FOP EDGE OF THE
LOWERING BAR.
ENTRAPMENT HAZARD –TO PREVENT DEATH FROM ENTRAPMENT, THE CO SLEEPER MUST BE PROPERLY
SECURED TO THE ADULT BED USING THE ATTACHMENT SYSTEM
STRANGULATION HAZARD: When the anchor plate and strap assembly are not in use, store in a safe
place not accessible to children.
Check the tightness of the attachment system before each use by pulling the bedside sleeper away from
the adult bed.
Gaps should not be filled with pillows, blankets or other items.
DO NOT allow children to climb or play on or under unit in any configuration.
FALL HAZARD: Remove infant from the bedside sleeper before starting any conversions.
• Before use in co sleeper mode (fixed to the bed), make sure the product is securely anchored and positioned.
• The crib should be locked in the fixed position when the child is left unattended.
• When the product is used in co sleeper mode(fixed to the bed), make sure the connection belts are locked and tensioned
properly, before laying child in the sleeper. The co sleeper must be secured to the parents mattress and no gaps between the
product and the adult mattress shall be present.
• Keep the fastening bells out of reach of children.
• Failure to follow these warnings and instructions could result in serials injury or death.
• Only use the attacment system supplied. Do not use another as it may not be suitable.
• Never use the crib in co sleeper position without the anchor plate attached and locked as shown in the instructions. Failure to use this
anchoring system could result in serious injury or death to the infant. Make sure all straps are secured and tight.
• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless otherwise advised by
your physician.
• A co sleeper is designed to provide a sleeping area for an infant until he or she begins to push up on hands and knees or
approximately 5 months of age. Move your child to another sleeping product when your child reaches this stage.
• NEVER raise the level of the bedside sleeper bassinet mattress.
Make sure all straps are secured and tight when used in the bedside sleeper position. Tighten straps periodically.
• NEVER leave your infant in the product without the TOP HORIZONTAL RALL installed in the upper most position ,unless securely
attached to the adult bed. Failure to use this securing system will allow the bedside sleeper to move away from the adult bed and
could result in the infant falling out of the bedside sleeper bedside bassinet.
• Always make sure all top and bottom rails are securely locked, in all configurations, before putting an infant child into the unit.
• To prevent serious or fatal injury from falls always keep child within arms reach.
The height of the parents mattress must be level or
higher than that of the side of the cot.
50 c
m
68 c
m