TIPS
Make sure you DO NOT push the base of the cot down before you lock the side rails.
Make sure you lift the base of the cot to its highest
position before attempting to unlock the rails.
To assemble the crib
1. Undo the Velcro straps to remove the mattress. Fig 1.
2. Make sure the base is in the upright position and then lift each of the side rails upwards until they lock in
place. Fig 2.
3. Only when all four top rails are locked, push the base down. Fig 3.
4. Place the mattress inside the cot with the Velcro straps facing downwards. Fig 4.
5. Thread the straps through the slots and secure underneath. Fig 5.
To use the bassinette
6. Zip the liner in to the inside of the cot. NOTE. There are two separate zips. One zips runs around the two
sides and the back and the front drop side zip is located below the level of the drop side rail. Ensure ALL
zips are connected securely before each use
7. Thread the loop and eye of the zip through the split ring ( fig 7a) and cover with the Velcro flap. Fig 7b.
8. Using a male and female support rods, insert them in to the base opposite each other and connect
together. Fig 8.
9. Place the mattress inside and secure it to the liner with the velcro straps.
WARNING The lowest position for the mattress is the safest. The lowest mattress position should be used
when the baby is able to support it’s own weight or sit up.
To fold for storage
10. Remove the mattress and liner if used. Using the loop in the bottom centre of the cot, lift up as far as
possible. Lift the side rails up and squeeze the unlocking button on the bottom of the rail. With the button
held in, lower the rail downwards. Repeat for all side rails. Fig 10.
11. Whilst lifting the loop, pull all four corners together and then wrap the mattress around it and secure
with the Velcro straps. Fig 11.
Fig 1.
Fig 4.
Fig 5.
Fig 3.
Fig 6.
Fig 7a.
Fig 7b.
Fig 8.
Fig 10.
Fig 9.
Fig 11.
Fig 2.
“CLICK”