Redexim RINK SP950, Руководство пользователя

Страница: 13 / 17

13
Replacing the brush roller
The brush roller (6) consists of 10 individual segments, which are interlinked. Both outer
segments are secured on the shaft, each with three grub screws (5). To replace the brush roller
proceed as follows:
- Loosen the grub screws (1) of the brush bearing on the right side.
- Loosen and remove the screws (2, 3) of the right brush bearing holder (4).
- Remove the right brush bearing holder (4).
- Remove the grub screws (5) on both sides of the brush roller (6).
- Detach all the brush segments to the right. Please pay attention to the
correct order and arrangement of the brush segments.
- Slide the new brush segments back onto the brush shaft. Pay attention to
the first and last segment.
- Mount the brush bearing block (4) using the screws (2, 3).
- Tighten the grub screws (1) of the brush bearing.
- Center the brush in the middle and tighten it if necessary with a bar clamp
so that the gearing interlocks fully.
- Remove the grub screws (5) from both outer segments of the new brush
roller.
- Drill into the brush shaft with a 5 mm drill approximately 4 mm deep .
- Attention: You cannot use the holes of the old brush roller.
-
Tighten the grub screws (5) on both sides back into the brush roller.