Redexim
11
6. Lift the machine above the ground and place the front leg in top position and secure
this with the R-clip.
7. Lower the machine to just above the ground and adjust the top rod in such a manner
that the machine is horizontal.
8. Connect the hydraulic hoses to the tractor.
!! Make sure that the 3-point pins are locked using the R-clips !!
9. Start the tractor and lift the machine off the ground.
6.2. Detaching the machine
The machine should be detached in the following manner (see
Figure 2
):
1. Drive to a place where the machine can be detached.
2. Place the front leg in the lower position, secure this with the R-clip and lower the machine carefully on
a flat horizontal floor ground.
3. Disconnect the hydraulic hoses.
!! Make sure that the machine and the tractor cannot move while you are detaching
them !!
!! Switch off the tractor engine before detaching the machine !!
4. Loosen the top rod
(4)
and remove it.
5. Loosen the lowest arms
(2)
.
6. Start the tractor and drive off.
7. SAFETY WHEN USING THE POWER BOX RAKE
Before using the Power Box Rake, you should check the following:
1. Are there slopes? The maximum slope is 20 degrees for this machine. Always go from top to
bottom.
2. Are there hard objects in the ground? If so, use the Power Box Rake at adjusted speed.
3. Is there danger of flying objects (e.g., golf balls) that distract the attention of the driver? If so, the
Power Box Rake
CANNOT
be used.
4. Is there danger of sinking/sliding away? If so, postpone the treatment.
5. If the soil is frozen or very wet, postpone the activities until conditions improve.
6. Do NOT make sharp curves when the Power Box Rake touches the ground.
8. PROCEDURES
The start procedure is
VERY
important. Follow the described procedure precisely, because otherwise
the Power Box Rake can get damaged. The rotor can rotate in both directions. It is important to stop
the rotor
before
reversing the rotating direction. Changing the rotating direction too fast can damage
the hydraulic engine.
!! Redexim-BLEC does not accept responsibility for damage to the hydraulic engine
due to operating errors by the operator !!
