Redemac Autolabel D43, Руководство пользователя

Страница: 13 / 38

2.4.4.3 ”Window length”
This setting determines during how long time from time window start an incoming trigger signal is
allowed. If a trigger signal is outside the time window the screen will display a warning ”Missing
trigger”. This setting is only available when ”trig type” 0 or 1 is set.
2.4.4.4 ”Apply delay”
This is the base delay from the trig input to the printing start. It is used to set the coarse label position
on the product, while the ”Label position” control on the ”Home” page (if active) is used for fine grained
position control.
Do not use values smaller than 50 ms.
2.4.4.5 ”Trig block time”
This setting is used to block new trig events for the specified time. This is useful when a single product
can generate multiple trig events. It is important to not set it too long, or the next product will not be
marked.
2.4.4.6 ”Blow delay”
This setting can be used to delay the blow application. It is normally never used since the blow
application works best when there is no delay.
2.4.5 Settings->Adjust
The tab "Settings" - "Adjust" mainly contains other non timing related printer settings
2.4.5.1 ”Print speed ”
Unit: mm/s. Can be up to 200 mm/s with good print quality. A lower setting (e.g. 160) can be beneficial
to achieve the highest print quality. This setting has effect on the label position. It can be compensated
by ”Apply delay”. See section 2..4.4.4.
2.4.5.2 ”Print contrast”
Unit: us. Autolabel D43 uses thermal print technology. Different label materials have different
sensitivities and the contrast can vary between different materials. Higher contrast means more
darker printouts. Worth thinking about is that high contrast can result in poor readability of the printed
barcodes. Normal levels are around 300-400 us.
2.4.5.3 ”Label width ”
Unit: mm. This affects how hard the rewinder roll will stretch the label paper. Appropriate values are 20
– 120 mm. Normally the value shall be the same as the actual label width. When the printer is used in
floury environment 40mm shall be added to the actual label width if possible.
2.4.5.4 ”Label length (mm)”
Unit: mm. This affects how far the machine will scan for the gap between labels when closing the print
head. It will scan 20mm longer than this setting. It can be beneficial to trim this setting for the specific
labels used in order to avoid excessive paper loops during adjustment.
2.4.5.5 ”Print offset ”
Unit: 1/12 mm. Normally fixed at 26, does not need to be adjusted
13
www.redemac.com 888-335-9570