CLEAN EVF SCREEN
NOTE: This section describes only how to clean the screen on the DSMC2
®
RED EVF, and not how to clean the entire
device.
This section explains how to clean the screen on the DSMC2 RED EVF. The screen is accessed by removing the
DSMC2 RED EVF Modular Optical Block.
Use an ionized rubber air bulb to clean the screen on the DSMC2 RED EVF. If there are still particles on the screen after
using an air bulb, gently wipe the screen with a rolled-up, particulate-free, non-abrasive optical-grade wipe.
NOTE: Cleaning the screen without first removing solid particles increases the risk of scratching the screen. As with
many screens, any type of physical contact with the screen may scratch the surface.
PROHIBITED EVF SCREEN CLEANERS
DO NOT use any of the items listed below to clean the screen on the DSMC2 RED EVF. These products have not been
tested on RED products and may cause damage or streaking.
Compressed air
Gas dusters
Solvents
Rubbing alcohol
Isopropyl alcohol
Windex
®
Third-party cleaning kits
Pre-packaged lens cleaner containing any additives, such as detergent, anti-static compounds, or fragrance
RED Microfiber Bag
WARNING: Damage to any screens or other components of the camera system caused by using prohibited cleaners is
not covered under warranty.
CLEAN LCD SCREENS
NOTE: This section describes only how to clean the screen on each specified device, and not how to clean the entire
device.
This section explains how to clean the screens on the following devices:
RED PRO LCD
RED Touch LCD
RED PRO Touch LCD
Camera Side LCD
C OPYR I GH T © 2 0 2 0 R ED . C OM , L L C
9 5 5 - 0 1 9 2 _ V7 . 3 , R EV- A
|
5 9
RED RANGER GEMINI OPERATION GUIDE
