COPYRIGHT © 2015 RED.COM, INC
RED MOTION MOUNT OPERATION GUIDE
955-0013, REV-K | 8
The RED MOTION MOUNT
®
is installed in the same way as other RED lens mounts. Installation and removal
steps provided in this section apply to the following lens mounts:
ITEM
PART NUMBER
DSMC
®
Mg PL Mount 2.0
725-0024
DSMC Ti PL Mount
725-0022
DSMC Al Canon
®
Mount
725-0026
DSMC Ti Canon Mount
725-0005
DSMC Al Nikon
®
Mount
725-0006
DSMC Ti Nikon Mount
725-0007
DSMC Al Leica-M
®
Mount
725-0008
DSMC MOTION MOUNT Ti PL
725-0012
DSMC MOTION MOUNT Ti Canon
725-0014
For more information on maintenance, go to
“MOTION MOUNT Maintenance” on page 25
.
WARNING:
Lens mounts are NOT HOT SWAPPABLE, meaning you cannot install or remove a lens mount while
the camera is turned on. Before installing or removing the lens mount you MUST turn off the camera. Failure to
do so may result in damage to the lens mount or camera that will not be covered under warranty.
WARNING:
Any damage to your camera, lens mount, or other equipment caused by the incorrect removal or
installation of lens mounts is NOT covered under any RED
®
warranty.
NOTE:
DO NOT allow dirt or debris to enter the camera opening during the installation or removal of a lens
mount. Take great care not to drop any screws into the camera opening, as damage may occur to the OLPF.
NOTE:
Always avoid physical contact with the MOTION MOUNT glass during installation or removal.
02
MOTION MOUNT
INSTALLATION