DA_Dual Ethernet - A
Drawing No. LP1112
Effective 07 2020
DA Dual Ethernet Sled
Installation Guide
1
PACKAGE CHECKLIST
This product package should contain the items listed below. If
any items are missing or damaged, contact Red Lion immediately.
- DA Dual Ethernet Sled
- Installation Guide
SAFETY SUMMARY
All safety related regulations, local codes as well as instructions
that appear in this document or on equipment must be observed
to ensure personal safety and to prevent damage to either the
device or equipment connected to it.
Do not use these products to replace proper safety interlocking.
No software-based device (or any other solid-state device) should
ever be designed to be responsible for the maintenance of
personnel safety or consequential equipment not equipped with
safeguards. Red Lion disclaims any responsibility for damages,
either direct or consequential, that result from the use of this
equipment in a manner not consistent with these specifications.
SPECIFICATIONS
1.
POWER REQUIREMENTS
: Power is supplied by the DA host
controller.
Max Power: 2.1 W
2.
INTERFACES:
Two 10/100 BaseTX RJ-45 Ports, auto MDI/ MDI-X.
Individual isolation from Ethernet network to controller:
1500 Vrms
3.
ENVIRONMENTAL CONDITIONS
:
Operating Temperature Range: -40 to 75 °C
Storage Temperature Range: -40 to 80 °C
Vibration to IEC 60068-2-6: Operational 5-500 Hz, 2 g
Shock to IEC 60068-2-27: Operational 15 g
Operating and Storage Humidity: 0 to 95% max. RH non-
condensing
Altitude: Up to 2000 meters
4.
CERTIFICATIONS AND COMPLIANCES
:
Refer to the controller manual for agency certifications.
CE Approved
EN 61326-1 Immunity to Industrial Locations
Emission CISPR 11 Class A
IEC/EN 61010-1
RoHS Compliant
5.
INSTALLATION REQUIREMENTS
: Sled must be installed
inside the unit case with the hardware provided. See
“Installing the Dual Ethernet Sled” for more details.
6.
WEIGHT
: 7.05 oz (200 g)
INSTALLING THE DUAL ETHERNET SLED
DA50 INSTALLATION
1. Prior to installing the Sled for your DA50 application, ensure
that the unit is not receiving power.
2. Disconnect and remove your DA50 from the DIN rail.
3. Remove the DA50 unit’s front cap by squeezing the sides and
pulling.
4. Slide out the sled holder.
5. Install the sled into the sled holder and hand tighten the
captive fasteners, or use a screwdriver.
6. Re-install the sled holder containing the sled into the
Converter. Make sure it is fully seated.
7. Replace the front cap.
CAUTION: Risk of Danger
Read complete instructions prior to installation and
operation of the unit.
ATTENTION : Risque de danger
Lire les instructions complètes avant l’installation et
l’utilisation de l’appareil.
CAUTION
: Follow standard ESD precautionary
procedures.
ATTENTION
: Suivez les procédures de précaution
standard de décharge électrostatique.
WARNING - Disconnect all power to the unit before
installing or removing sleds.
AVERTISSEMENT - Débranchez l’alimentation électrique
de l’appareil avant d’installer ou de retirer les tiroirs.
z
Dual 10/100TX Ethernet communication
z
Industrial rated for harsh environments
z
Wide operating temperature range
z
Simplified deployment architecture
z
Field installable
z
Individually isolated ports
For use with DA50 and DA70 series covered in DEMKO 20 ATEX
2268X and IECEx UL 20.0007X certificates
