REDCAST MODulE OPERATION GuIDE
COPYRIGHT © 2015 RED.COM, INC
955-0072, REV-H | 19
SET GENLOCK OFFSET
If the video feed is delayed, adjust the genlock offset for the REDCAST Module.
1. Go to one of the following menus (available menus are determined by DSMC firmware):
‒
v5.3 or v6.0
: Menu > Settings > Display > REDCAST
‒
v6.0
: Menu > Settings > Display > Monitor Control > Advanced > REDCAST
2. Select the genlock offset from the
Genlock
drop-down menu. Range is –8,000 pixels to 10 pixels. Default
is 0 pixels.
‒
Negative offset
: Advances the video, so the video reaches the switcher earlier than it would otherwise.
‒
Positive offset
: Advances the video, so the video reaches the switcher later than it would otherwise.
3. Continue to adjust the genlock offset until the video ingest equipment indicates that the video signal aligns
with the genlock signal.
