INTERCHANGEABLE OLPF SYSTEM
WARNING:
Read these instructions carefully and in their entirety before removing or installing an OLPF. Damage to
the OLPF module, camera, or sensor due to improper handling or use is not covered under warranty.
WARNING:
Once an interchangeable OLPF is removed from the camera, the sensor is exposed. Improper handling of
the OLPF modules or camera during this procedure may compromise the installation or cause irreparable damage to
your camera or sensor.
WARNING:
DO NOT allow any dirt or debris to enter the optical cavity.
WARNING:
Use only DSMC2 OLPFs. DO NOT use DSMC OLPFs. For any questions about OLPF compatibility,
please contact your Bomb Squad representative.
SWAP AN INTERCHANGEABLE OLPF
REQUIRED TOOLS:
T20 TORX driver
1. Turn off the camera.
2. Remove any modules, cables, or other accessories that may interfere with operations.
3. Loosen and remove the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using a T20
TORX driver.
NOTE:
Some lens mounts have captive screws that are not removable.
NOTE:
Screw removal may require a large handle T20 TORX driver and additional leverage.
4. Remove the lens mount.
5. Use a damp, lint-free cloth to gently wipe down the area around the lens mount and OLPF module. Remove as
much dust and debris as possible.
6. Use a T20 TORX driver to turn the OLPF lock on the camera counter-clockwise by a third turn to the Unlock
position. DO NOT turn the indicator mark past the Unlock icon.
WARNING:
DO NOT OVERTIGHTEN.
Figure: Turn the Lock Counter-Clockwise
C O PYR I G HT © 2 0 1 7 R ED.C O M , I NC
9 5 5 - 0 1 1 6 _V 6 .3 , R EV - M
|
4 8
WEAPON/SCARLET-W OPERATION GUIDE
