background image

Flame Engineering Inc.  •  PO Box 577  •  LaCrosse KS 67548  •  800-255-2469  •  785-222-2873  •  785-222-3619 Fax  •  www.FlameEngineering.com

Owner Manual/Assembly Instructions

Red Dragon Patio Lights

NOTE: Unpack and inspect for damage. Retain this information sheet for future reference.

FOR YOUR SAFETY...

DO NOT use this Patio Light in areas where gasoline 

or other flammable liquids are stored or used.

 Intended for outdoor use only.

Check with local 

natural gas or propane 

supplier for ordinances, 

requirements, etc. prior 

to installation of your 

new Patio Light. Check 

all gas connections 

prior to lightup, 

ensuring a safe and 

operative unit.

• Visually inspect Patio Light prior to each use. Ask a qualified service person to 

inspect hose assembly annually for evidence of abrasion, wear or cuts. Replace hose 

assembly if any of these conditions are present.

• Read all instructions and warnings contained in this manual.

• Follow procedures step by step.

ALWAYS

Cylinder not included!

Temperatures near Patio Light Head will ignite 

combustible materials. Use only on level and 

stable surfaces. Keep Patio Lite Head at least 6’ 

away from any combustible materials.

WARNING

Содержание patio light

Страница 1: ...rdinances requirements etc prior to installation of your new Patio Light Check all gas connections prior to lightup ensuring a safe and operative unit Visually inspect Patio Light prior to each use Ask a qualified service person to inspect hose assembly annually for evidence of abrasion wear or cuts Replace hose assembly if any of these conditions are present Read all instructions and warnings con...

Страница 2: ... Hammer an adjustable end wrench C Cart Rear View D D E Axle Caps 3 8 x 1 4 Set Screws Valve F A B1 B2 C D 5 16 Button Head Cap Screw 5 16 Button Head Cap Screw Flame Engineering Inc PO Box 577 LaCrosse KS 67548 800 255 2469 785 222 2873 785 222 3619 Fax www FlameEngineering com Turn all valves to an off position Head valve must be turned clockwise to be in an off position Open source cylinder val...

Страница 3: ...n the set screw hole Insert 5 16 inch button head cap screw G and tighten with allen wrench provided 5 Connect fuel supply hose D to Patio Light head E No pipe compound is necessary on this connection as this is a flare fitting Tighten with wrench 6 Insert upper post section C into Patio Light head collar E Insert the 3 8 inch x 1 4 inch set screws F and tighten with allen wrench provided 7 When i...

Страница 4: ...ration or hot DO NOT allow children to play on or around the Patio Light It could cause a fire or bodily burns Place in a low traffic area DO NOT leave unattended Close gas valves when unattended or not in use Installation must comply with all applicable codes Patio Light must be set level and comply with minimum clearance of 6 from all sides Using soapy water check all gas connections for leaks a...

Отзывы: