C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 3 , R EV - AB
|
3 4
RED MOTION MOUNT OPERATION GUIDE
APPENDIX B:
MOTION MOUNT COMPATIBILITY
The DSMC
®
RED MOTION MOUNT
®
S35 Ti PL and DSMC RED MOTION MOUNT S35 Ti Canon
®
(Captive) enable
you to mount most PL cinema lenses and Canon EF compatible lenses to your camera.
WARNING:
Using lenses, adaptors, or other accessories that are not compatible with the MOTION MOUNT may
damage the internal glass or other elements in the lens mount.
WARNING:
Lenses, adaptors, and other PL-mount devices with mounting elements that protrude more than 27.73 mm
behind the PL mounting flange are not compatible with the MOTION MOUNT.
NOTE:
Any damage to the DSMC RED MOTION MOUNT S35 Ti PL or the camera system caused by using
incompatible lenses (including non-standard PL lenses) or devices is not covered under warranty.
COMPATIBILITY REQUIREMENTS
Some lenses are NOT compatible with the MOTION MOUNT due to the liquid crystal glass and shape of the baffle
inside the mount.
Refer to the following diagram to determine if the maximum protrusion depth and maximum protrusion diameter of a
particular lens is compatible with the MOTION MOUNT. If any of the protruding lens elements extend beyond these
dimensions, the lens is NOT COMPATIBLE.
DO NOT use lenses that have mounting elements that exceed the following values:
Maximum Protrusion Depth
: 27.73 mm
Maximum Protrusion Diameter at a Protrusion Depth of 14.20 mm
: 54.00 mm
Maximum Protrusion Diameter at a Protrusion Depth of 27.73 mm
: 22.00 mm
WARNING:
Use of a lens that extends beyond these dimensions may damage the MOTION MOUNT.
Figure: MOTION MOUNT Safe Zone
