REMOVE LENS MOUNTS
NOTE:
You can change lens mounts in the field. However, RED recommends that you change lens mounts only in a
dust-free environment.
REQUIRED TOOL(S):
T20 TORX
®
driver
1. Turn off the camera.
2. Attach the camera to a stable platform or position the camera on a clean and level work surface so that the lens
mount screws are accessible.
3. Remove the lens and any camera modules, cables, or other accessories that might interfere with removing the lens
mount.
4. If removing the DSMC Mg PL Mount 2.0, turn the locking ring slightly counter-clockwise so that you can access
the lens mount screws.
Figure: Turn Locking Ring Counter-Clockwise
5. Loosen and remove the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using a T20
TORX driver.
NOTE:
Some lens mounts have captive screws that are not removable.
NOTE:
Screw removal may require a large handle T20 TORX driver and additional leverage.
Figure: Remove the Lens Mount Screws
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 3 , R EV - AB
|
1 1
RED MOTION MOUNT OPERATION GUIDE
