LED Floodlights
Installation Instructions
Page 1
Red Arrow Trading
Elsworth House, Herries Road South,
Sheffield, S6 1QS
T:
0800 195 0006
F:
0870 043 3946
E:
www.redarrowtrading.com
This installation must be carried out by an electrician.
Please read these instructions carefully before installation.
Leave a copy for the user/maintenance engineer for future reference.
For models: LEDFL30B-RGB
Product complies with
all relevant European
standards
Product is suitable for
mounting on flammable
material
F
Important Installation Information
•
Installation should be carried out in accordance
with the latest edition of the I.E.E. wiring
regulations (BS7671) and taking into consideration
the latest Building Regulations. If in doubt, consult
a qualified electrician.
IMPORTANT: Ensure that ALL electrical
connections are tight with no loose strands,
including factory made connections.
•
Input voltage – 85V-240V
•
Ensure there is adequate free air circulation of at
least 100mm around the luminaire. All luminaires
run hot. It is the installer’s responsibility to consider
fire risk and take appropriate precautions.
•
Before commencing installation or maintenance,
ensure electricity is switched off at the mains.
•
The nearest illuminated surface must be at least
0.5m from the front of the fitting.
Specification
•
LED Floodlight
•
Class I (must be earthed)
•
Wattage: 30W
•
Lamp type (included): LED
•
Lumen Output: 2400lm (depending on model).
•
Supply voltage: 85V-265V
•
IP Rating: IP65
•
Material: Black, Die Cast Aluminium
Important User Information
•
Always switch off mains supply before servicing, fitting
or maintenance.
•
Allow the LED and fitting to cool before replacing LED.
Installation Instructions
•
Check for concealed cables before drilling fixing holes.
•
Remove the bracket pulling out the two bolts on both sides.
•
Fix the bracket to a wall or similar hard surface.
•
Fix the body to the bracket.
Maintenance
•
Before any maintenance ensure the product has cooled
down.
•
This product is supplied ready to use. No maintenance should
be required, except if damaged or the front glass cover is
broken. In either case please contact your supplier.
Cleaning
•
Depending on the application, clean the glass cover at
regular intervals, and remove all dust or dirt to ensure
luminaire works correctly.
•
Use cotton duster (no alcohol, no solvent), only water to clean
glass.
Usage of RGB LED Remote Controller
Key infared controller adapts the advanced micro control
unit, it is used for controlling a variety of LED lamps. It can
adjust brightness, static colour choices and various dynamic
changes in lighting effects through infared remote control.
•
Please take off the insulating film before using the infared
remote control.
•
When operating the remote control, it must face the
infared receiver. Please ensure there is no barrier between
the remote controller and the receiver.
•
The distance between the remote controller and the receiver
must be less than 10m.
**Please turn overleaf for Key Functions for Remote Control.
PRN WEE/BJ1331XR
