REBOTEC /
BA-Nr.: 02.07.132/2021-11-A01
- 9 -
EN
•
Pressing (2) the lever forward brakes the 24"
wheel. Push the lever all the way down!
•
If the braking effect is not sufficient or if the braking
effect decreases after some time of use, it is nec-
essary to adjust the parking brake.
Individual setting and adjustment of the
parking brake must only be carried out by
the specialist dealer. This also applies to
the replacement or repair of a parking brake.
12.9 Tilt and fall protect
•
To overcome obstacles, the self-propelled unit can
be tilted backwards. This raises the front wheels
and an obstacle can thus be overcome.
•
Hold the backrest with both hands and tilt the chair
backwards until the two support legs are almost on
the floor.
•
By pulling out the clip, the tilt protect tube can be
pulled off
13 Troubleshooting
Fault
Potential cause
Remedy
Armrest can-
not be swiv-
elled down
Deposits in the
locking device
(locking bolt)
Cleaning,
checking reg-
ularly
Locking bolt
cannot be
pulled out
Deposits, tension
spring jammed or
defective
Cleaning,
Replace the
locking bolt
Footrest can-
not be folded
down
Deposits in the
joint,
Bracing
Cleaning,
Check screw
connection
Wheel lock
does not brake
General defect
see mainte-
nance!
Fault
Potential cause
Remedy
Turning the
wheel is stiff
Deposits
Cleaning
Wheel does
not turn
General defect
see mainte-
nance!
Uneven run-
ning of the
wheel
Severe uneven
tread wear
see mainte-
nance!
Chair frame
too unstable
Screw connections
too loose
Screw con-
nections:
Tighten
frame, wheel
inserts
Wheel insert
bent/distorted
Hitting an obstacle
see mainte-
nance!
14 Care and maintenance
14.1 Cleaning and care
•
The product can be cleaned using a
mild conventional cleaning and disinfecting
agent. After cleaning, wipe the product with a
clean, moist cloth and then wipe it dry with a dry
cloth.
•
Do not use scouring agents or cleaning agents
with aggressive ingredients (acids, thinners), as
well as hard cleaning objects (brushes), as other-
wise the surfaces may be damaged or deposits
may form on the materials.
•
The product is suitable for manual cleaning and
disinfection. Please observe the reprocessing in-
structions (02.12.156).
14.2 Maintenance
•
Wear and tear that is not recognised in time and/or
improper handling, as well as irregular or no
maintenance may result in accidents.
For safety reasons, the product must be
professionally maintained at least once a
year.
•
Check product for visible damage (cracks, breaks,
loose parts)
•
Check stability before use
Maintenance/inspection scope
•
Maintenance should include the following inspec-
tion work and should be documented.
•
All bolted connections for tightness (especially the
wheel inserts and the frame)
•
Function of the armrests and locking bolts
•
Function of the footrest (replace defective foot-
rests)
2
