background image

Robert H Peterson Co. Model: RR-2A

9-2-20 Page 1

Model: RR-2A

INSTALLATION AND OPERATING INSTRUCTIONS

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION           

INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE

INTRODUCTION

This remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas 
heating appliances.  It has a built-in thermostat.  This all battery system operates independently of household current.  
The system operates on radio frequencies with a non-directional signals.  The systems operating range is approximately 
20-feet.  The system operates on one of 1,048,576 security codes that are programmed into the transmitter at the factory; 
the remote receiver’s code must be matched to that of the transmitter prior to initial use. It is designed to be used with 
millivolt gas valves as a dry contact switch.

Review COMMUNICATION SAFETY SECTION under TRANSMITTER section. These signal/temperature 

VDIHW\IHDWXUHVVKXWGRZQWKH¿UHSODFHV\VWHPZKHQDSRWHQWLDOO\XQVDIHFRQGLWLRQH[LVWV

TRANSMITTER

This remote control SYSTEM offers the user a battery-operated remote 
control that operates most millivolt gas valves used in some heater rated 

JDVORJVJDV¿UHSODFHVDQGRWKHUJDVKHDWLQJDSSOLDQFHV

The transmitter operates on (2) 1.5V AAA batteries.

It is recommended that ALKALINE batteries always be used for longer 
battery life and maximum operational performance.

Before using the transmitter, install the (2) AAA transmitter batteries into 
the battery compartment. (Use caution that batteries are installed in the 
proper direction)

ON

MODE

OFF

SET

1

2

3

4

BUTTON SETTINGS

1.   

ON

 - - - 

2.  

 OFF

 - -

3.  

 MODE

4.   

SET

 --

 - 

Turns appliance ON
Turns appliance OFF
Cycles control between manual and thermo mode.
Sets temperature in thermo mode.

NOTE:

7KLVSURGXFWLVGHVLJQHGIRUXVHZLWKDQDWWHQGHGKHDUWKDSSOLDQFHRU¿UHIHDWXUH$GXOWVPXVWEHSUHVHQWZKHQ

WKH&RQWURO6\VWHPLVRSHUDWLQJ'2127SURJUDPRUWKHUPRVWDWLFDOO\VHWWKLV&RQWUROWRRSHUDWHDKHDUWKDSSOLDQFHRU¿UH
IHDWXUHZKHQ$GXOWVDUHQRWSK\VLFDOO\SUHVHQW)XUWKHUPRUH'2127OHDYHWKHKHDUWKDSSOLDQFHRU¿UHIHDWXUHEXUQLQJ
XQDWWHQGHGLWPD\FDXVHGDPDJHRUVHULRXVLQMXU\,IDQ$GXOWLVJRLQJWREHDZD\IURPWKHKHDUWKDSSOLDQFHRU¿UH

feature for any length of time, then the handheld/wall mount, receiver/control module and application should be in the 
“OFF” position.

ON

MODE

OFF

BUTTON

WALL CLIP

SLOT

FRONT

BACK

OFF

SET

ON

BUTTON

MODE

BUTTON

SET

BUTTON

BATTERY

COMPARTMENT

f i r e - p a r t s . c o m

Содержание RR-2A










Отзывы: