5
3.3 Charging the battery
For an optimum lifetime, you should charge the battery as often as possible. If the battery is not charged
regularly, it will be damaged due to self-discharge. Frequent deep discharge reduces the battery life.
During charging, the RPP10 must be connected to a control box.
To charge the battery, do the following:
1. Connect the RPP10 to a control box, see section 3.2.
2. Connect the battery charger to the RPP10 charger jack and to a wall socket.
3. Check that the LED on the charger is red, indicating charging.
4. The charging time is approximately 9 hours.
When the charging is completed, the LED on the charger is green.
Only use the battery charger delivered together with the RPP10.
Charging must take place in a room with good air ventilation.
The ambient temperature must not be below 0°C or above 40°C.
If the RPP10 has not been used for a long time, it is recommended to charge the
battery for 24 hours.
3.4 Checking battery level
To check the battery charge level, you must connect the RPP10 to a RCB11 or RCB12 control box. For
more information, refer to the user manual for the control box.
